Traders Airsoft Forums

Hey all,

Recently one of the parts was sheared off on one of my revolvers. It's the little thing connected to the trigger that locks the cylinder in alignment. I doubt I'll be able to find a replacement so I was wondering if any of the great minds around here had any advice on how to fix/re-make it.



Since it's a relatively high-stress part, it just snaps off when repaired using superglue or metal epoxy. I'm wondering if it's possible to weld something so small, and I've also been considering getting a new one made by someone like ProG4, but I have no idea where to start with that or how much it would cost.

Anyone?

Thanks!

That cylinder latch is off of a S&W style revolver, no?
It's actually very similar to the real one; if you can get some measurements I can take a look and see how close it is to a real S&W part.

Yes, it's the latch from an S&W N-frame. I see what you mean about the RS parts, they're available for pretty cheap and they look almost exactly the same. Even if they're not a drop-in fit some dremel work should solve that.

The curvy part is about 2.4mm wide, the base is about 7.1mm wide and 8.5mm tall. Thanks!

I will check those measurements against a real one at work on monday and let you know.

Did you check? Thanks again.