Traders Airsoft Forums

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Damn that's a nice carbine setup.

(09-02-2010 10:28 AM)RacingManiac Wrote: [ -> ]

How is the new Guarder slide?

Quite nice. Its lighter than my old stainless one, needs a bit of sanding under the chamber to work better with my older Guarder outer barrel. But once fitted it works well...

The separate extractor piece is a nice touch but needed to be glued in to stay on. I like the way SD does it better, which is physically retained by how the piece is cut and pinched by the BBU...

(09-16-2010 07:18 PM)RacingManiac Wrote: [ -> ]Quite nice. Its lighter than my old stainless one, needs a bit of sanding under the chamber to work better with my older Guarder outer barrel. But once fitted it works well...

The separate extractor piece is a nice touch but needed to be glued in to stay on. I like the way SD does it better, which is physically retained by how the piece is cut and pinched by the BBU...

Is the Guarder frame going strong?

So far so good, there is much JB Weld reinforcement that the front portion of the metal inner cannot be removed anymore.

Beautiful G19, makes me miss my old one.

Any reason why you went with the tlr-1 and not the tlr-1s? Same to RM? You both seem to have the tlr-1. I've been looking into one and they both are just over $100 varying only by like 5-10 bucks.

KSC GLOCK 26
[Image: KSCGLOCK26.jpg]