Traders Airsoft Forums

Yay my first pic in this thread.

If you don't know, my other hobby is to collect anime figurine. This is a figurine from Shunya Yamashita and she's holding an M4.

This is one of my project.







Least to say I'am very happy with the result and yes... the gun does shoot. With a 11.1v Li-mn in the stock.

I love my job!

My WA M4 2nd phase, the G&P stock pipe is great, but the metal body is not that great, it wobbles like crazy :-(

What do you mean wobbles like crazy? From what points?

IT SHAKES, and there's a gap between the upper to the lower
i will post a pic later on when I get a chance to show you

That sucks..
How was the install? Easy or fitting required?

that installation is easy, other than the wobble, it's great

How did you get the forward assist assembly back in? Did you have to cut the spring down? I have the G&P Zombie Killer MBK and when I install the forward assist, the spring binds up and holds the forward assist against the bolt carrier.

i actually sand the forward assist button, it was a little bit bigger so use some 400 sand paper to sand it down just a bit, the spring on mine is fine, no cutting was needed

Armalite day one....KA Vltor M4 CASV CQB...